Improve compressor efficiency with easy-to-install Hard Start kits from Hartland Controls. Hard Starts allow A/C units and heat pump compressors to start-up at maximum efficiency, so the unit can reach normal rated speed up to ten times faster. Hard Starts are also useful in difficult conditions such as low voltage or undersized wiring, and reduce light dimming during compressor start-up. Eliminate the heat surge that typically occurs at start-up, and help extend the life of the compressor, terminals, windings and capacitor.
- Use on 1/2 to 10 HP Single Phase HVAC Compressor or Refrigeration Unit
- Positive Temperature Coefficient (PTC ) Relay and Capacitor
- Easy 2-wire installation
- Increase in torque 500%
- Instant re-start
- UL® Recognized
- NATE® Recognized
- Prop 65 Warning (Cadmium)
- RoHS compliant
- REACH compliant
AC Voltage
90–277
Temperature
–40 to +65 Celcius
Frequency
50/60 Hz
Capacitance
130–156 µF
Replacement Part Number | Manufacturer |
DST-6 | Diversitech® |
SPP6 or SPP6E | Supco® |
32702 or 35702 | MARS® |
TQS6 or HS6 | Packard® |
T600-052 | Robertshaw® |
HS650 | Gemline® |
- Hard starting compressor
- Low voltage situation